Related Manuals for Xhorse Dolphin Generation 2 XP-005L
Summary of Contents for Xhorse Dolphin Generation 2 XP-005L
- Page 1 Dolphin Generation 2 Maintenance Manual V1.0 Note: This manual is applicable to models with serial number KM10、KM11 of Dolphin GenerationⅡmodel.
- Page 2 DOLPHIN XP-005L Dolphin Generation 2 Maintenance Manual V1.0 Machine disassembly exploded pictures...
- Page 3 DOLPHIN XP-005L Dolphin Generation 2 Maintenance Manual V1.0...
-
Page 4: Replace The Battery
DOLPHIN XP-005L Dolphin Generation 2 Maintenance Manual V1.0 2 Method of replacing parts due to machine malfunction 2.1 Replace the battery Please refer to the disassembly pictures P1, P2, P3, and P4 in Chapter 1. Remove the screws in the red frame separately to replace the battery module with a new one, and plug in the three wiring ports of the battery accordingly. - Page 5 DOLPHIN XP-005L Dolphin Generation 2 Maintenance Manual V1.0 2.4 Replace the spindle motor belt Due to long-terms use, the belt should be replaced in a timely manner when it ages, breaks or slips (breaking the cutter during cutting). Refer to P1 and P2 in Chapter 1, remove the screws in the black frame to remove the rear cover, then refer P5 to remove the screws in the yellow frame at ⑥⑦, and then rotate the Z-axis in the red circle clockwise to its highest position, then refer P6 to remove the screw from the red frame at ①②...
-
Page 6: Replace The Sensor
DOLPHIN XP-005L Dolphin Generation 2 Maintenance Manual V1.0 2.6 Replace the sensor 2.6.1 Replace the X-axis sensor When the sensor is defective or damaged, it needs to be replaced. Please refer P1 and P2 to remove the screws in the green frame and remove the rear cover, then refer P5 to remove the screws at position X in the white frame at ⑧, then replace it. - Page 7 DOLPHIN XP-005L Dolphin Generation 2 Maintenance Manual V1.0 2.8 Replace or inspect the cutter wires 2.8.1 The cutter non-conductive Poor contact or broken circuit caused by worn probe wires, refer chapter 2.7.1 to replace the probe and cutting wires. Insert the mainboard port according to the wire harness label. 2.8.2 The cutter remains conductive Refer to chapter 2.7.1, check if the cutter wire is broken, and if there are metal debris near the fixing screws or at...
- Page 8 DOLPHIN XP-005L Dolphin Generation 2 Maintenance Manual V1.0 2.11 Replace the key switch and USB port Replace the key switch needs to refer the P1 and P2 and remove the screws in the black frame, and remove the rear cover, then refer to the picture on the right, remove the screws securing the switch on the rear cover in the green frame, then replace it.
- Page 9 Shenzhen Xhorse Electronics Co.,Ltd Address:2801-2805, 2901-2905, Block A, Building 6, Shenzhen International Innovation Valley, Dashi 1st Road, Xili community, Nanshan District, Shenzhen...