Table of Contents
Advertisement
REACT V BMB
Figure 10. ZTH EU – Hand-held terminal for setting and reading
the actuator's parameters.
OK
Browses up or down, and changes values/status
Confirms selected value/goes to selected sub menu
OK
esc
Cancels change/leaves the sub menu
esc
i
i
Shows additional information, if available
Settings for hand-held terminal ZTH EU
To access the settings, press and hold OK and power up the
hand-held terminal. Exit with esc.
Display text
8
Swegon reserves the right to alter specifications.
Language
>English
i
esc
OK
i
esc
OK
Description
Change of language
Change of unit
Activation of expert mode
Activation of advanced mode
Duration of background lighting
Clearing of the memory
Settings for actuator
Display text
20230929
Description
Identification of actuator
Serial number
Actuator type
Software version
Designation
Position
Shows the actual value
Shows the set point value
Shows the actual value
Shows Δp
Shows the actual value
Shows damper position
Shows the actual value
Forced control
Normal operation
Actuator stops in the current position
Damper regulates to selected max. value
Damper regulates to selected intermediate position
Damper regulates to selected min. value
Closes the damper fully
Opens the damper fully
Direction of rotation. Available in advanced mode.
Anti-clockwise (standard, may not be changed)
Clockwise
Factory reset
Available in expert and advanced mode
Adjusts to desired min. value
Min. value must be lower than the max. value
Adjusts to desired intermediate value
Available in expert mode
Adjusts to desired max. value
Max. value must be higher than the min. value
Shows the nominal air flow
Pressure on which nominal air flow is based
Available in expert mode
Number of metres above sea level
Available in advanced mode
Address 1...127
Base address 0...200
Available in advanced mode
Choice of transfer speed
Parity
Internal termination
Choice of bus protocol
Choice of bus control or analogue control
Advertisement
Table of Contents
