Bescheinigung Des Herstellers/Importeurs - Roland ep-3 Owner's Manual

Hide thumbs Also See for ep-3:
Table of Contents

Advertisement

SAVE THESE INSTRUCTIONS
For the U.K.
BLUE
: NEUTRAL
BROWN
: LIVE
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying
the terminals in your plug proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
The product which is equipped with a THREE WIRE GROUNDING TYPE AC PLUG must be grounded.
For West Germany
Bescheinigung des Herstellers/Importeurs
Hiermit wird bescheinigt, daB der/die/das
in Ubereinstimmung mit den Bestimmungen der
Roland ep.
Amtsbl. Vig
(Gerät. Typ. Bezeichnung)
(Amtsblattverfügung)
funk-entstört ist.
Der Deutschen Bundespost wurde das Inverkehrbringen dieses Gerätes angezeigt und die Berechtigung zur Überprüfung
der Serie auf Einhaltung der Bestimmungen eingeräumt.
f
Roland Corporation Osaka/Japan
a ae Zr ru ze Er rr
oo Er Sr
Er er
Er er
re Ser
e
Name des Herstellers/Importeurs
For the USA
RADIO AND TELEVISION INTERFERENCE
WARNING —
This equipment has been verified to comply with the limits lor a Class B computing device, pursuant to Subpart J, of Part 15, of FCC rules. Operation with
non-cerlilied or non-verified equipment is likely to result in interference to radio and TV reception.
The equipment described in this manual generates and uses radio frequency energy. If il is not installed and used properly, that is, in strict accordance with our instructions,
it may cause interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class B computing device in accordance
with the specifications in Subpart J, of Part 15, of FCC Rules. These rules are designed to provide reasonable protection against such a interference in a rasidential installation.
However, there is no guarantee that the interference will not occur in a particular installation. II this equipment does cause interference to radio or television reception, which
can be determined by tuming the equipment on and off, the user is encouraged to try to correct the interference by the folowing measure:
* Disconnect other devices and their input/output cables one at a time. If the interference stops, it is caused by either the other device or its VO cable.
These devices usually require Roland designated shielded 1/O cables. For Roland devices, you can obtain the proper shielded cable Irom your dealer. For non Roland
devices, contact the manufacturer or dealer for assistance.
H your equipment does cause interference to radio or television reception, you can try to correct the interference by using one or more o! the following measures.
Turn the TV or radio antenna until the interference stops.
Move the equipment to one side or the other of the TV or radio.
Move the equipment farther away from the TV or radio
Plug the equipment into an outlet thal is on a different circuit than the TV or radio. (That is, make certain the equipment and the radio or television sel are on circuits con-
trolled by different circuit breakers or fuses.)
Consider installing a rooftop television antenna with coaxial cable lead-in between the antenna and TV. If necessary, you should consult your dealer or an experienced
radio/lelevision technician for additional suggestions. You may find helpful the following booklet prepared by the Federal Communications Commission:
"How to identity and Resolve Radio — TV interference Problems"
This booklet is available from the U.S. Government Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.
For Canada
CLASS B
NOTICE
This digital apparatus does not exceed the Class B limits for radio noise emissions set out in the Radio Interference
Regulations of the Canadian Department of Communications.
CLASSE B
AVIS
Cet appareil numérique ne dépasse pas les limites de la classe B au niveau des émissions de bruits radioélectriques fixés
dans le Reglement des signaux parasites par le ministére canadien des Communications.

Advertisement

Table of Contents
loading

Table of Contents