Table of Contents
Advertisement
Trouble shooting
en
The "Fill water tank" message
appears even though the water tank
is full
The panel for removing the tank does
not open
When you cook with steam, a lot of
steam is produced
When cooking with steam, a lot of
steam is produced repeatedly
There is a "pop" noise during cooking Cold/warm effect with frozen
--------
:
Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Error messages on the display
When an error message appears on the display with "D"
or "E", e.g. D0111 or E0111, switch the appliance off
and on again using the ÿ On/Off button.
If it was a one-off error, the display goes out. If the error
message appears again, call the after-sales service and
quote the exact error message.
40
The panel is open
The water tank is not clicked
into place
Faulty sensor
The water tank has fallen off.
Due to the impact, compo-
nents inside the water tank
have come loose, and the
tank is leaking.
The plug is not plugged into
the mains
Power cut
The circuit breaker is faulty
v field sensor faulty
The appliance is being auto-
matically calibrated
The appliance is unable to cal-
ibrate itself automatically if
cooking times are too short
food, caused by the steam
Close the panel
Click the water tank into place
~ "Steam" on page 18
Call the after-sales service
Order a new water tank
Connect the appliance to the electricity supply
Check whether other kitchen appliances are working
Check in the fuse box to make sure that the fuse for the appliance is in work-
ing order
Call the after-sales service
If required, empty the water tank: Open the appliance door, take hold of the
lower part of the panel on the left and right with your fingers and pull out the
panel
Normal procedure
Reset the appliance to the factory settings and repeat the calibration process
Not possible
Maximum operating time
If you do not change the settings on your appliance for
several hours, the appliance stops heating up
automatically. This prevents unwanted continuous
operation.
The respective settings for the operating mode govern
when the maximum operating time is reached.
Maximum operating time reached
A note appears on the display confirming that the
maximum operating time has been reached.
To continue operation, touch any field or turn the rotary
selector.
Switch the appliance off using the ÿ On/Off button if
you do not need to use it.
Set a cooking time so that the appliance does not
Tip:
switch off when you do not want it to, e.g. with an
extremely long preparation time. The appliance heats
up until the set cooking time has elapsed.
Cooking compartment bulbs
To light the interior of your cooking compartment, your
appliance has one or more long-life LED bulbs.
However, if ever an LED bulb or the bulb's glass cover
is defective, call the after-sales service. The lamp cover
must not be removed.
Advertisement
Table of Contents
