Advertisement
Installing the Cover at the
Other Side of the Machine
Repeat the steps for following procedures at the other
side of the machine:
1.
Loosening Track Tensioning (page 1)
2.
Installing the Cover (page 2)
A.
Drilling the Frame Plate (page 2)
B.
Assembling the Cover (page 3)
3.
Adjusting the Track Tension (page 3)
Running the Track and
Checking the Track Tension
1.
Remove the jack stands and lower the machine
to the ground.
2.
Drive the machine, then park the machine on a
level surface, engage the parking brake, shut off
the engine, and remove the key.
3.
Raise the side of the machine that you are
adjusting so that the track is off the ground.
4.
Verify that the track deflection is 13 mm (1/2
inch) as shown in
If track deflection is too large or too small,
remove the tensioner locking bolt and adjust
the track tension; refer to
Tension (page
1. Road wheel
5.
Lower the machine to the ground.
6.
Repeat steps
3
the machine.
4
Figure
7.
Adjusting the Track
3).
Figure 9
through
5
at the other side of
g257979
Advertisement
