Table of Contents
Advertisement
Inserting the milk valve
Do not switch on the coffee machine
while the milk valve is removed.
Insert the stainless steel bolt from
above.
Insert the silicone seal into the milk
valve holder.
Insert the holder and silicone seal
until they audibly click into place.
Connect together the angular molded
hose and longer milk pipework. Start
by attaching the top of the molded
hose to the central spout. The black
connecting piece should be pointing
to the rear.
Cleaning and care
Then, connect the bottom end of the
molded hose to the dispensing unit.
Insert the milk pipework into the milk
valve on the left and right-hand sides.
Push the connecting pieces into the
silicone seal as far as they will go.
Check that the milk pipework is snug
against the housing and that the
cover can be easily attached.
Tip: If necessary, screw the milk
pipework backward at the connecting
piece on the right-hand side.
Attach the milk valve cover as
follows: insert the pin in the top right-
hand corner and swivel the cover
backward until a proper fit is
achieved.
63
Advertisement
Table of Contents
