Lithium Battery Warning - SonicWALL NSA 3600 Safety And Regulatory Information Manual

Hide thumbs Also See for NSA 3600:

Getting started manual (64 pages)

Table Of Contents

Table of Contents

Available languages

 Mount in a location away from direct sunlight and sources of heat. A maximum ambient temperature of

104º F (40º C) is recommended.

 Route cables away from power lines, fluorescent lighting fixtures, and sources of noise such as radios,

transmitters, and broadband amplifiers

 If installed in a closed or multi-rack assembly, the operating ambient temperature of the rack

environment may be greater than the room ambient. Therefore, consideration should be given to

installing the equipment in an environment compatible with the maximum recommended ambient

temperature.

 Mount the SonicWall appliances evenly in the rack in order to prevent a hazardous condition caused by

uneven mechanical loading.

 Four mounting screws, compatible with the rack design, must be used and hand-tightened to ensure

secure installation. Choose a mounting location where all four mounting holes line up with those of the

mounting bars of the 19-inch rack mount cabinet.

 A suitably rated and approved branch circuit breaker shall be provided as part of the building

installation. Follow local code when purchasing materials or components.

 The included power cord(s) are approved for use only in specific countries or regions. Before using a

power cord, verify that it is rated and approved for use in your location.

 Minimum power cord rating for European Union (CE): Certified power supply cord not lighter than light

PVC sheathed flexible cord according to IEC 60227, designation, or H05 VV-F or H05 VVH2-F2, and rated

for at least 3G 0.75 mm².

 Ensure that no water or excessive moisture can enter the unit.

 Allow unrestricted airflow around the unit and through the vents on the side of the unit. A minimum of

1 inch (25.44mm) clearance is recommended.

 Consideration must be given to the connection of the equipment to the supply circuit. Appropriate

consideration of equipment nameplate ratings must be used when addressing this concern. Do not

overload the circuit.

 Reliable grounding of rack-mounted equipment must be maintained. Particular attention must be given

to power supply connections other than direct connections to the branch circuits, such as power strips.

 The following statement applies only to rack-installed products that are GS-Marked: This equipment is

not intended for use at workplaces with visual display units, in accordance with §2 of the German

ordinance for workplaces with visual display units. To avoid incommoding reflections at visual display

workplaces this device must not be placed in the direct field of view.

 Thumbscrews should be tightened with a tool after both installation and subsequent access to the rear

of the product.