Table of Contents
Advertisement
13.2
Lubricant - Selection
FUCHS
SHELL
Renolit FEP 2
Alvania EP 2
Stabylan 5006
--
--
--
13.3
Lubricant for food industry – Selection (as option*)
SHELL
Gearing
FM Grease HD2
Load chain
--
Load hook;
Pulleys
FM Grease HD2
Gear rim;
Drive pinion
* must be mentioned by order
14
Trouble
Please pay attention to the following in case of problems:
Troubles with the equipment must only be repaired by qualified personnel.
Secure the unit against unintended operation start.
Put up a warning note indicating that the unit is not to be used.
Secure the working area of moving parts of the unit.
Please read the chapter "Safety instructions".
Notes on the repair of faults are found in the following table.
For the repair of failures please contact our service department.
CAUTION!
Trouble caused by wear or damage to parts such as wire ropes, chains, chain wheels, axes, bearings,
brake parts, etc., must be remedied by replacing the parts with original spare parts.
15
Remedy
Trouble
The load is no longer pulled
16
Decommissioning
WARNING!
It is essential that the following points are observed in order to prevent damage to the equipment or critical
injury when the device is being decommissioned:
It is mandatory that all steps for decommissioning the machine are carried out in the indicated sequence:
First secure the working area for decommissioning, leaving plenty of space.
Read the chapter "Safety instructions".
Disassembly is carried out in reverse order to the assembly.
Please make sure that all operating material is disposed of in accordance with environmental regulations.
12
ESSO
MOBIL
Unirex EP 2
Mobilux EP 2
--
--
--
--
Chain lubricant OKS 451
MOBIL
Mobilgrease FM 222
Optimol Viscoleb 1500
Lubricant FM 100
Mobilgrease FM 222
Cause
Clamping jaws are worn
The clamping jaws are blocked.
Damage of wire rope
Overload caused shearing-off of the safety pin.
TOTAL
CASTROL
MULTIS EP2
--
--
Optimol Viscoleb 1500
--
--
KLÜBER
CASTROL
--
Klüberoil 4UH 1-1500 N
--
--
--
Remedy
Replace them by new, original clamping jaws.
Remove obstacle, check clamping jaws and wire rope for
damage and replace if necessary.
Check the wire rope and replace it by a new special wire
rope if necessary.
Reduce the load, replace the safety pin by a new original
safety pin.
KLÜBER
--
Klüberoil 4UH 1-1500
Wolfracoat 99113
5.52.270.00.01.04
Advertisement
Table of Contents
