Page 1
Scope of Supply/Bill of Material & Mounting Drawings Part Number: H-CRF300L-09-01-AL / H-CRF300L-09-02-AL Part Description: Engine Guard–HONDA CRF300 L Applicable to Finished colour versions of Silver Installation / Parts List / Bill of Material for Mounting Copyright By SRC Design and Specification are subjected to change...
Page 2
Mounting Instructions Step 1: Motorbike which shows the four mounting holes (shown in Red colour) SRC Engine guard will use these four mounting holes for fitment of Engine Guard. Step 2: Mounting of Rear End Bracket (8) Orient the Rear End Bracket, as shown, and slip-in the Long Bolt (Original Equipment –...
Page 3
Engine Guard, slip-in the Taper Ring (4) – 2 off and Screw M6 x 50 (2) – 2 off and secure the threads . Copyright By SRC Design and Specification are subjected to change Page 3...
Page 4
Symmetry of the Engine Guard from the frontal side and tighten the fasteners to torque as specified in the BOM table The Engine Guard “As is final Mounted Condition” Copyright By SRC Design and Specification are subjected to change Page 4...
Vehicle. We have prepared this based on our experience and knowledge, related to the Vehicle, Part and its functional aspects. 3. SRC cannot guarantee the interchangeability of the parts to any other manufacturer’s accessory part. It is advised to the User, to inspect and ensure the original state of all other Vehicle parts.