Advertisement
Rear End Bracket in "As is mounted
condition"
Copyright By SRC
Design and Specification are subjected to change
Step 3:
Mounting the Engine Guard
Orient the Engine Guard for
mounting it to the Rear End Bracket,
as shown.
Slip-in the Taper Ring (4) – 2 off and
M6 x 15 Screw (3) – 2 off and secure
the threads using Nut – 2 off, from
the inside of the Bracket, as shown.
Mounting the Engine Guard from the
frontal end
Slip-in the Bush Spacer (5) – 2 off
between the mounting surface of
the holes (as shown in "Red") and
from the frontal side of the Engine
Guard, slip-in the Taper Ring (4) – 2
off and Screw M6 x 50 (2) – 2 off and
secure the threads .
Page 3
Advertisement
