Startup - True TAC-30 Installation Manual

True Food Service Equipment, Inc.

STARTUP

Step 6
A. The compressor is ready to operate. Plug in the unit.
PLEASE REVIEW THE FOLLOWING CAUTIONS WHEN THE
OPTIONAL HEATED PAN IS USED.
This unit has two power supply cords. Unplug both
cords before moving or servicing this appliance.
This unit has two power supply cords. Connect
each plug to a receptacle that is connected to an
individual branch circuit.
This unit has more than one disconnect switch (plug).
B. Temperature control set at No. 4 position gives
refrigerators an approximate temperature of 33°F to
38˚F (.5˚C to 3.3˚C). Allow unit to function several
hours, completely cooling cabinet before changing
the control setting.
C. Excessive tampering with the control could lead to
service difficulties. Should it ever become necessary
to replace temperature control, be sure it is ordered
from your True dealer or recommended service
agent.
D. Good air flow in your True unit is critical. Be careful
to load product so that it neither presses against
the back wall, nor comes within four inches of the
evaporator housing. Refrigerated air off the coil must
circulate down the front of the shelves.
9
INSTALLATION / OPERATION INSTRUCTIONS
CAUTION:
CAUTION:
CAUTION:
............ www.truemfg.com ............
NOTE
If the unit is disconnected or shut off, wait five minutes before
starting again.
RECOMMENDATION
Before loading product we recommend you run your True unit empty
for two to three days. This allows you to be sure electrical wiring
and installation are correct and no shipping damage has occurred.
Remember, our factory warranty does not cover product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for your unit.
If at any time during the life of your display case, a part is needed,
you may obtain this part by furnishing the model number and serial
number to the company from whom you purchased the cabinet. Call
Toll-Free: (800)-424-TRUE (Direct to Parts Department). (800)-325-
6152 (U.S.A. & Canada only) or call: (636)-240-2400.
Serial Number
9