Operation; Startup - True TFP-72-30M-D-2 Installation Manual

Undercounters worktops sandwich/salad pizza prep & food prep
Hide thumbs Also See for TFP-72-30M-D-2:
Table of Contents

Advertisement

TRUE
refrigerated prep
TPP REAR BUMPER INSTALLATION
KIT CONTENTS
Bumpers (2)
Screws (2)
TOOLS REQUIRED
Phillips Screwdriver
STEP 1
After removing cardboard crate, locate and remove bag of shelf clips
and bumpers that are secured to the box containing the castors.
STEP 2
Remove the cutting board from the back of the TPP.
STEP 3
Locate both pre-drilled holes in the back outer wall.
STEP 4
Remove 2 screws and 2 bumpers from the bag.
STEP 5
Install bumpers and screws with Phillips screwdriver.

OPERATION

STARTUP

A. The compressor is ready to operate. Plug in the cooler.
B.
Temperature controls are factory-set to give refrigerators
an approximate temperature of 35°F (1.6°C) and freezers
an approximate temperature of -10°F (-23.3°C). Allow unit
to function several hours, completely cooling cabinet before
changing the control setting.
Temperature Control Location and Settings.
• Electronic temperature control is located on rear of unit or
behind access grill.
• LAE temperature control is located on the front of cabinet
countertop or in/behind louvered grill.
• Mechanical temperature control is located inside of unit.
See website for adjustments, sequence of operation, and more
information.
C. Excessive tampering with the control could lead to service
difficulties. Should it ever become necessary to replace
temperature control, be sure it is ordered from your TRUE
dealer or recommended service agent.
9
1
3
5
D. Good air flow in your TRUE unit is critical. Be careful to
load product so that it neither presses against the back wall,
nor comes within four inches of the evaporator housing.
Refrigerated air off the coil must circulate down the back wall.
NOTE: If the unit is disconnected or shut off, wait five minutes
before starting again.
RECOMMENDATION - Before loading product we recommend
you run your TRUE unit empty for two to three days. This allows you
to be sure electrical wiring and installation are correct and no ship-
ping damage has occurred. Remember, our factory warranty does not
cover product loss!
.
.
www
truemfg
com
2
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tpp-67Tssu-48-10Twt-67d-2Tuc-67-hc

Table of Contents