Installation / Operation Instructions Ownership; Required Tools; Uncrating; Locating - True TAC-30 Installation Manual

True Food Service Equipment, Inc.
INSTALLATION / OPERATION INSTRUCTIONS
OWNERSHIP
To insure that your unit works properly from the
first day, it must be installed properly. We highly
recommend a trained mechanic and electrician
install your True equipment. The cost of a
professional installation is money well spent.

REQUIRED TOOLS

• Adjustable Wrench
• Phillips Head Screwdriver
• Level

UNCRATING

Step 1
The following procedure is recommended for
uncrating the unit:
A. Remove the outer packaging by pulling tri-wall
nails from skid. Remove (4) cardboard corner
pads and dust cover.
B. Inspect for concealed damage. Again,
immediately file a claim with the freight carrier
if there is damage.

LOCATING

Step 2
A. Remove packing material behind cabinet as a
cushion. Carefully lay the unit on its back to
remove skid.
When lifting unit remember to leave the
cabinet upright for 24 hours before
plugging into power source.
B. Remove skid by unscrewing all base rail anchor
brackets. Place skid to the side.
C. Carefully lift cabinet upright.
Removing skid
from bottom of
cabinet.
5
INSTALLATION / OPERATION INSTRUCTIONS
............ www.truemfg.com ............
Before you start to install your True unit, carefully
inspect it for freight damage. If damage is
discovered, immediately file a claim with the
delivery freight carrier.
True is not responsible for damage incurred during
shipment.
C. Move your unit as close to the final location as
possible before removing the wooden skid.
Installation Tips
• Place cabinet in an area that will not have any
air drafts.
• Excessive airflow around cabinet can effect
interior cabinet airflow (air-curtain).
• No HVAC supply or return air vents pushing air
into or pulling air out of cabinet.
• No doorways.
• No ceiling fans.
• Do not place into direct sunlight.
Check for correct clearance space in back of
cabinet and above. A 4" clearance requirement
for the rear of cabinet and 12" clearance
above cabinet.
• Maximum ambient condition 75 degrees and
55% Relative Humidity.
NOTE:
5