M36 107B3 GS_3
56
9
Go to cover page
Miscellaneous
Monitor Turned Off
If the monitor is "hard powered off" while a window or area is highlighted
and then hard powered on again, LightFrame
icon may still show the feature as still active. In this case, you have to
™
exit LightFrame
and restart it via the icon on the desktop or the Start
menu.
->turn off -> turn on ->see
green
click
-->
-> see
-->
->see
-------->
-> click
If the Monitor is Detached and Another Monitor is Attached
If the monitor is detached from the computer while a
highlighted window or area is displayed and then another
monitor is attached, the system will have to be rebooted
so that Philips' LightFrame™ can detect the monitor's
LightFrame™ capabilities and store the setup information
about the new monitor. If the monitor is not LightFrame™
capable, an Error message appears. See Error Message
2 under the heading Error Messages. You can abort or
continue the set up. However, if you continue,
LightFrame™ may not work with the monitor.
Error Messages
You may see this message when you install LightFrame™.
Error Message 1 dialog box here
LightFrame™ cannot detect a monitor which supports this
feature. You can still proceed with the software installation
but LightFrame™ might not run on your system.
You may see this message when you try to switch
monitors.
Error Message 2 dialog box here
LightFrame™ cannot detect a monitor which supports this
feature. You can still start the software but LightFrame™
may not work.
Back
LightFrame for Windows (Continued)
™
™
is no longer active. The
->
gray
gray
-> click
-->
-> recover
Forward