Advertisement
SINGLE GANG ELECTRICAL BOX MOUNT - CM-331/43S-SGLR
1. a) If using an in-wall box ensure the box is plumb and
square, and flush with the wall surface. (See Diagram 1)
b) If using a surface box, ensure it is secure & plumb.
2. Bring your 4 or 6-conductor wire through the back or side
of the enclosure and leave approximately 6" tail for
wiring connection.
3. Make the electrical connections to the device according to
the wiring section.
4. Using the dip switch located on the end of the unit, set the
operating mode.
CM-331/43S-SGLR Surface Mount
CM-331/42S-SGLR Label
CM-331/42S-SGLR Label
5. Attach the unit to the enclosure using the two #6-32
screws provided.
6. Apply power and adjust range and time delay via the
potentiometers on the front of the unit.
7. Attach the faceplate to the unit using the two black
#6-32 x 1/2'' machine screws or tamperproof screws.
NOTE: Do not overtighten!
8. Apply the label as required.
Wall
CM-331/42SW-SGLR Label
WC16PS SERIES RESTROOM CONTROL
IN S TALL AT ION INSTRUCTIO NS
CM-331/43S-SGLR Flush Mount
Wall
Page 4 of 13
Advertisement
