Table of Contents
Advertisement
REAR BRAKE SHOE INSPECTION/BRAKE FLUID LEVEL INSPECTION
(TT-R125LW/TT-R125LWE)/SPROCKETS INSPECTION
REAR BRAKE SHOE INSPECTION
1. Inspect:
Brake shoe lining wear limit
G
Brake shoe lining wear limit checking
steps:
Fully push down the brake pedal and hold
G
it in position.
Then check the brake shoe wear indicator
G
1 is within the wear limit a.
Outside the limit →
Refer to "REAR WHEEL AND REAR BRAKE"
section in the CHAPTER 5.
BRAKE FLUID LEVEL INSPECTION
(TT-R125LW/TT-R125LWE)
1. Place the brake master cylinder so that
its top is in a horizontal position.
2. Inspect:
Brake fluid level
G
Fluid at lower level → Fill up.
a Lower level
Recommended brake fluid:
DOT #4
WARNING
Use only designated quality brake fluid to
G
avoid poor brake performance.
Refill with same type and brand of brake
G
fluid; mixing fluids could result in poor
brake performance.
Be sure that water or other contaminants
G
do not enter brake master cylinder when
refilling.
Clean up spilled fluid immediately to
G
avoid erosion of painted surfaces or plas-
tic parts.
SPROCKETS INSPECTION
1. Inspect:
Sprocket teeth a
G
Excessive wear → Replace.
NOTE:
Replace the drive, driven sprockets and drive
chain as a set.
3 - 20
INSP
ADJ
Replace the brake
shoe.
Advertisement
Table of Contents
