Honda CB1100 2018 Owner's Manual page 84

Drive Chain Adjusting the Drive Chain Slack
u
Turn both adjusting bolts an equal
5.
number of turns until the correct drive
chain slack is obtained. Turn the adjusting
bolts counterclockwise to tighten the
chain. Turn the adjusting bolts clockwise
and push the rear wheel toward the front
to provide more slack. Adjust the slack at
a point midway between the drive
sprocket and the driven sprocket.
Check the drive chain slack.
Check rear axle alignment by making sure
6.
the end of the chain adjusting plate aligns
with the scale graduations on both sides
of the swingarm. Both marks should
correspond. If the axle is misaligned, turn
the right or left adjusting bolts until the
marks are aligned and recheck chain
slack.
80
7.
Torque: 113 N·m (11.5 kgf·m, 83 lbf·ft)
8.
9.
If a torque wrench was not used for
installation, see your dealer as soon as
P. 77
possible to verify proper assembly.
2
Improper assembly may lead to loss of
braking capacity.
Tighten the rear axle nut.
Hold the adjusting bolts and tighten the
lock nuts.
Recheck drive chain slack.