Table of Contents
Advertisement
Section V
Operation
This section describes the basic steps required to operate the instrument. It is recommended that
the following information be carefully read.
5.1
Preliminary
checkout
A. Observe the line voltage ra ting on the rear panel nameplate and make certain it conforms
with your AC line voltage.
B.
Push the female line cord connector firmly into the socket of the instrument and connect the
other end
to
your AC outlet.
C.
Push the
PWR
switch.
The GA 1E indicator will flash and the Counter Display will read
the
frequency of the signal.
D. Preset
the
controls:
Ail controls pushed
in.
Ail non-power buttons released.
AMPL and OFFSET set to
midposition.
DUTY control at CAL position
FREQUENCY control fully counterclockwise.
5.2
Square, Triangle, or Sine wave output
A.
Push
the desired FUNCTION button for square, triangle, or sine wave output.
B. Push
the desired Range button (lM, lOOk,
lük,
lk,
100,
10, 1) for the desired frequency.
C.
Rotate
the FREQUENCY knob until the desired frequency appears in the Frequency
Display
window.
11
Advertisement
Table of Contents
