Advertisement
Mast-Arm Installation
1.
Loosen 2 x M10 hex grub screws, feed power cable through
spigot and cable gland, adjust alignment and tighten screws.
Adjust throw by loosening 2 x M8 cap screws, adjust in
reference to markings and tighten screws.
2 x M8 Hex socket cap screws
Tighten to 10 Nm
Post-Top Installation
1.
Loosen 2 x M10 grub screws, feed power cable through spigot
and cable gland, adjust alignment and tighten screws. Adjust
throw by loosening 2 x M8 cap screws, adjust in reference to
markings and tighten screws.
2 x M8 Hex socket cap screws
Tighten to 10 Nm
2 x M10 Hex socket grub screws
2 x M10 half lock-nuts
Tighten to 10 Nm
2 x M10 Hex socket grub
screws
2 x M10 half lock-nuts
Tighten to 10 Nm
3
Advertisement
