Hisense FV21C7HWE User's Operation Manual page 6

Tools you will need:
Not provided
Philips Screwdriver &
Slotted Screwdriver
Provided
H
●
To allow the doors to self-close, tilt the
top backwards by about 10mm.
You can adjust them manually by hand or
using a suitable spanner.
Note:
●
 If required you may lay the refrigerator
on its back in order to gain access to the
base, you should rest it on soft foam
packaging or similar material to avoid
damaging the backboard of the
refrigerator.
 There is no need to install these
5
accessories under normal usage.
Only under the extreme circumstances,
that is opening the door about 90
degrees, this refrigerator may take risk of
tipping.
Then rubber supporting pad should be
fastened to the lower base cover to
Allen wrench steady this appliance.
1. Tilt appliance to find screw hole on the
left of lower base cover.
andle supports
Handle
2. Put screw into the hole of rubber
supporting pad.
3. Make screw in alignment with the hole
on lower base cover. Fasten rubber
supporting pad to the base cover firmly by
a cross screwdriver (self-provided).