Cleaning And Care - Hisense FV21C7HWE User's Operation Manual

Cleaning and Care
●
For hygienic reasons the appliance
(including exterior and interior
accessories) should be cleaned at least
every two months.
Warning!
To avoid electrical shock, the appliance
must not be connected to the main power
supply during cleaning. Before cleaning,
switch the appliance off and remove the
plug from the main socket.
Exterior cleaning
To maintain good appearance of your
appliance, you should clean it regularly.
Spray water onto a cleaning cloth
instead of spraying directly on the
surface of the appliance. This helps
ensure an even distribution of moisture
to the surface.
Clean the doors, handles and cabinet
surfaces with a mild detergent and then
wipe dry with a soft cloth.
Caution!
Don't use sharp objects to clean with, as
they are likely to scratch the surface.
Don't use Thinner, Car detergent,
bleach, ethereal oil, abrasive cleansers or
organic solvent such as Benzene for
cleaning. They may damage the surface
of the appliance and may cause fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean when
food stocks are low. Wipe the inside of the
fridge freezer with a weak solution of
backing soda and water, and then rinse
with warm water using a wrung-out
sponge or cloth. Wipe completely dry
before replacing the shelves and baskets.
Thoroughly dry all surfaces and
removable parts before putting them back
into place.
Although this appliance automatically
15
defrosts, a layer of frost may occur on the
freezer compartment's interior walls if the
freezer door is opened frequently or kept
open too long. If the frost is too thick,
choose a time when the freezer is nearly
empty and proceed as follows:
1. Remove existing food and accessories
baskets, unplug the appliance from the
main power and leave the doors open.
Ventilate the room thoroughly to
accelerate the process.
2. When defrosting is completed, clean
your freezer as described above.
Warning!
Do not use sharp objects to remove frost
from the freezer compartment. Only after
the interior is completely dry should the
appliance be switched back on and
plugged back into the main socket.
Door seals cleaning
Take care to keep door seals clean. Sticky
food and drinks can cause seals to stick
to the cabinet and tear when you open the
door. Wash seal with a mild detergent and
warm water. Rinse and dry it thoroughly
after cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on
Replacing the LED light
Warning: The LED light must be replaced
by a competent person. If the LED light is
damaged, follow the steps below:
1. Unplug your appliance.
2. Remove light cover by rising up and
pulling out the LED light.
3. Hold the LED light with one hand and
●
pull it with the other hand while pressing
the connector latch.
4. Replace LED light and snap it correctly
in place and recover the light cover.