Download Print this page

Sony LBT-G2000 Operating Instructions Manual page 6

Advertisement

'@olalacadcelac
FeV Van
csi el ere Gelalersaqcela|
Connect the supplied loop antenna to the AM and +h
terminals.
You can attach the loop antenna on the wall using
commercially available screws.
ZE \
=
Sy
«
at
flat)
( —
SN
ht
A\ =I
For better reception
In addition to the loop antenna, connect an insulated wire of
20- to 50- feet (6 to 15 meters) to the AM terminal (the lower
terminal). Be sure not to disconnect the loop antenna.
Adding Other Components
to the System
Connecting a video equipment (for LBT-G2000)
You can connect a video equipment to the VIDEO IN jacks
only for the audio input signal.
To select the video equipment, press the VIDEO button.
Note
When this system is turned on, noise may occur during radio
reception or in the picture and sound of the video
equipments (TV, VTR, etc.). In this case, place this system
away from the video equipments or turn off the power of the
unit.
VIDEO
IN
Connecting a turntable (for LBT-D250)
You can connect a turntable system (PS-LX56, etc.) to the
PHONO jacks. To listen to analog discs, press the PHONO
button.
AC Power
Cord
8)
Connect the AC power cord to a wall outlet.
Note
Memories stored in the unit may be lost when the AC power
cord is disconnected for a certain period of time.
Turning on the Power
Press the POWER button to turn on the power after
completing all connections.
Changing
the AM Tuning
Interval
The unit tunes in AM stations at 10-kHz intervals. To use the
unit where the tuning interval is 9-kHz, change the setting as
follows:
. 1 Turn on the power.
2 Tune in any AM station.
3 Turn off the power.
4 While pressing the DUAL MODE TUNING + button, turn on
the power.
To reset the interval, repeat the same procedure.
Nea] exeyacelane
@ Stored stations will be erased from the memory when you
change the interval.
@ Stored stations will be erased from the memory when the
AC power cord is disconnected for a long time.

Advertisement

loading

This manual is also suitable for:

Lbt-d250