Table of Contents
Advertisement
9
Power cord set requirements
This chapter provides power cord requirements for countries and regions.
The wide-range input feature of the computer permits it to operate from any line voltage from 100 V AC
to 120 V AC, or from 220 V AC to 240 V AC.
The three-conductor power cord set included with the computer meets the requirements for use in the
country or region where the equipment is purchased.
Power cord sets for use in other countries or regions must meet the requirements of the country and
region where the computer is used.
Requirements for all countries
These power cord requirements are applicable to all countries and regions.
●
The length of the power cord set must be at least 1.0 m (3.3 ft) and no more than 2.0 m (6.5 ft).
●
All power cord sets must be approved by an acceptable accredited agency responsible for
evaluation in the country or region where the power cord set will be used.
●
The power cord sets must have a minimum current capacity of 10 A and a nominal voltage rating of
125 V AC or 250 V AC, as required by the power system of each country or region.
●
The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard
Sheet C13 connector for mating with the appliance inlet on the back of the computer.
Requirements for specific countries and regions
To determine power cord requirements for specific countries and regions, use this table.
Table 9-1
Power cord requirements for specific countries and regions
Country/region
Argentina
Australia
Austria
Belgium
Brazil
Canada
Chile
Denmark
Finland
France
64
Chapter 9 Power cord set requirements
Accredited agency
IRAM
SAA
OVE
CEBEC
ABNT
CSA
IMQ
DEMKO
FIMKO
UTE
Applicable note number
1
1
1
1
1
2
1
1
1
1
Advertisement
Table of Contents
