Samsung SC06H70 0H Series User Manual page 19

Troubleshooting
PROBLEM
Motor does not start.
Suction force is
gradually decreasing.
In operation, the
vacuum cleaner stops
after repeating runs
and stops three times.
Cord does not rewind
fully.
Vacuum cleaner dows
not pick up dirt.
Low or decreasing
suction.
Body overheating.
Static electicity
discharge.
The vacuum cleaner
makes a strange
noise.
This vacuum cleaner is approved by the following:
Electromagnetic Compatibility Directive : 2004/108/EEC
Low Voltage Directive : 2006/95/EC
SOLUTION
• Check cable, pulg and socket.
• Leave to cool.
• Check for blockage and remove.
• Please unclog the intake.
• Pull the cord out 2-3 m and push down the cord rewind button.
• Check hose and replace if required.
• Please check filter and, if required, clean as illustrated in the
instructions. if filters are out of condition change them to new
ones.
• Please check filters, if required clean as illustrated in the
instruction.
• Please decrease power suction.
• This can also occur when air in the room is very dry.
Please ventilate the room till air humidity becomes normal.
• In order to protect the motor in the cleanr, it rotates slowly when
you just turn on the cleaner.
(Before the motor stabilizes,) this causes the loud noise at the
initial state and it is not failure in the machine.
Troubleshooting _19