Specifications - Pioneer VSX-3000 Operating Instructions Manual

TROUBLESHOOTING
TV source can't be seen
when the VCR's TV tuner is
used.
structions for your VCR.
Video tape copies can't be
made with the VCR.
made.
SPECIFICATIONS
Amplifier. Section
[VSX-3000]
Continuous Average Power Output is 60
watts* per channel, min., at 8 ohms from
20 Hertz to 20,000 Hertz with no more
than 0.05% total harmonic distortion.
Continuous Power Output (both channel driven)
1 kHz, T.H.D. 0.05%, 8 Qe ceeeeee 65 W + 65 W
20 Hz — 20 kHz, T.H.D. 0.3%, 6Q ...... 75W+75W
Input (Sensitivity/Impedance)
PHONO MM oun. cccccccceeeeeetcterseeeteteeseees 2.5 mV/50 kQ
CD, TAPE, VCR, VDP one eeeeeeereeees 150 mV/50 kQ
Phono Overload Level (T.H.D. 0.05%, 1,000 Hz)
PHONOiMIM Sesscctocortsvecctoves sodeoetzeecsecinectebesseieuepeenys 120 mV
Output (Level/Impedance)
MARE sREC» cnsscscdscteieciactvesteliet walrcoseveieiaes ies 150 mV/4 kQ
VCR UR EC assee Gaetan icsccsveheintiens enteuncenvess 150 mV/4 kQ
ADAPTOR OUT ......ccccccceseccsseesessessseeesenees 150 mV/2.2 kQ
Frequency Response
PHONO MM... eee 20 Hz to 20,000 Hz +0.3 dB
CD, TAPE, VCR, VOP. ........... 5 Hz to 70,000 Hz § dB
Hum and Noise (IHF, short circuited, A network)
PHONO MM) seecgeccccn cies ni anses diana 73 dB
CD, TAPE , VCR, VDP oe eeeceeeeeeteeteeteeeee .. 96 dB
PHONO (new IHF) .......... .. 74 dB
Others: ccc cdevvesseg oredowdiectadendeiees .. 77 dB
Graphic Equalizer frequency Band on. ec ceesesseeeeneeee
100 Hz, 330 Hz, 1 kHz, 3.3 kHz, 10 kHz, +8 dB
VCR Noise Filter oo... cceeeseeeeceees 100 Hz, 5 kHz, -3 dB
Loudness Contour ............ 8 dB (100 Hz), 3 dB (10 kHz)
Channel separation
PHONO: dash ans iniiieerissciaaanieves 60 dB/1 kHz
CD, TAPE, VCR, VDP 60 dB/1 kHz
does not work.
@ TV antenna is not connected to VCR, or con- ® Consult the VCR's operating instructions, and
nections are faulty. connect antenna correctly.
© You are attempting to watch a TV source using | ®@ Disconnect the copy system connection (TV
a VCR with copy system connections.
In general, when copy system connections are
made, the VCR's TV tuner function ceases to
operate. For details, consult the operating in-
@ Video tape copy connections haven't been
tuner function will operate).
® Look again closely at the section VIDEO SYS-
TEM CONNECTIONS on page 9, and connect
correctly.
[VSX-2000]
Continuous Average Power Output is 50
watts" per channel, min., at 8 ohms from
20 Hertz to 20,000 Hertz with no more
than 0.1% total harmonic distortion.
Continuous Power Output (both channel driven)
1 KHz, T.H.D. 0.1%, 892 veesceseesseessteeseeee 55 W + 55 W
1 kHz, T.H.D, 0.5%, 6 Q2 .occcceceseeeeteteeteeees 65W+65W
Input (Sensitivity/Impedance)
PHONO: MM sievtsctcciceccsicvetects ascoccnnente ces 2.5 mV/50 kQ
CD, TAPE, VCR, VDP wceecsereereeseee 150 mV/50 kQ
Phono Overload Level (T.H.D. 0.05%, 1,000 Hz)
PHONO: MM seessctssedssssesasiegesscoeses cateutegtisnseadgesteosiaess 120 mV
Output (Level/Impedance)
TAPE REC sic cscsveisssikesactsasasesiscsauzaies 150 mV/3.9 kQ
VCR REC © inccciesiiststseccescraistaseecdaeneni dies 150 mV/3.9 kQ
ADAPTOR OUT ooececceecteeeteteteeteeeeeneees 150 mV/2.2 kQ
Frequency Response
PHONO MM. q... eee 20 Hz to 20,000 Hz +0.3 dB
CD, TAPE, VCR, VDP. ........... 5 Hz to 70,000 Hz 3 dB
Hum and Noise (IHF, short circuited, A network)
PHONO(MM «sv cesccseceneavesten seer iieiiedenne erin 73 dB
CD, TAPE - VCR. VDP oe ceccecsceecressececeeetenteneenes 96 dB
PHONO (new IHF)
Others. c..devichs. Heliiatc ne cateamen cis cases
Graphic Equalizer frequency band
100 Hz, 330 Hz, 1 kHz, 3.3 kHz, 10 kHz, +8 dB
Channel! separation
60 dB/1 kHz
60 dB/1 kHz
* Measured pursuant to the Federal Trade Commission's Trade
Regulation rule on Power Output Claims for Amplifier.
27
<ARB1045>