Tape Copying - Pioneer DC-777Z Operating Instructions Manual

BASIC OPERATIONS
Erasing the tape (function of Deck Il only)
When recording on a previously recorded tape. the previ-
ously recorded sounds will be erased and new recording
entered on the tape. To erase a previously recorded tape
without recording anew, perform the following operations:
1 Load the cassette tape into Deck Il.
2 Set Deck | to the stop mode.
3 Push the FUNCTION switch in the
TAPE position.
4 Push the REC and PLAY switches at a
time to begin erasing.
RELAY PLAY (from Deck | to Deck Ii)
Relay play is possible from Deck | to Deck II but not vice
versa.
1 Load the pre-recorded cassette tapes
to be played back into Deck | and Deck
ii}
2 Press the PLAY switch on Deck I, then press the
PLAY switch on Deck Il. Deck | will be set to
the playback mode and Deck II to the play-
back standby mode.
3 When Deck | has finished playing and
stops automatically, Deck Ii will auto-
matically begin playback.
4 When the tape in Deck Il has reached
its end, the relay play will automati-
cally stop.
TAPE COPYING (from Deck I to Deck II)
Load the playback tape (pre-recorded original tape) into Deck
| and the tape for recording into Deck II. When performing
tape copying, the copy will have the same characteristics as
the tape in Deck | (original tape), regardless of the position
of the Dolby NR switch.
Set HIGH SPEED COPY switch to the appropriate position.
Then push SYNCHRO REC START switch. Never reverse
the order of the steps. Otherwise tape copying may not be!
[performed correctly.
® HIGH SPEED COPY
Push the HIGH SPEED COPY switch to
ON.
2? Push down the SYNCHRO REC START
switch to ON
3 To stop the tape copying. push both
STOP switches.
NOTE:
When performing 'high speed tape copying, tape copying will
take place regardless of the position of the FUNCTION switch.
However, sound heard from the speakers will be that of source
selected by the FUNCTION switch.
e@ NORMAL SPEED COPY
Release the HIGH SPEED COPY switch
to OFF
2 Push the FUNCTION switch in the
> PAPE position.
<ARB1078>
Push down the SYNCHRO REC START
switch to ON.
4 To stop the tape copying, push the
both STOP switches.
NOTE:
When performing tape copying at normal speed, be sure to set
the FUNCTION switch to the TAPE position. if set to any other
position, the signal from that source will be recorded.
| TURNTABLE
The illustration shows
model PL-8882.
Cp IOS
SPEED switch oS
ARM-ELEVATION
switch
[ PL-7772Z
RECORD PLAY
Press the FUNCTION switch and set it
to PHONO.
Place the record on the platter mat.
Remove the stylus cover and release
the tonearm from the arm rest.
Set the SPEED switch.
Move the ARM-ELEVATION switch to the
UP position.
Move the tonearm by hand across the
record. At this stage, the platter starts
to rotate.
Move the ARM-ELEVATION switch to the
DOWN position.
To stop the player while a record is being
played, press the STOP switch.
—~ Arm rest
oS Tonearm
START/STOP switch
SIZE switch
on OO Of WH =|
PL-888Z
RECORD PLAY (Auto play)
Press the FUNCTION switch and set it
to PHONO.
Place the record on the platter mat.
Remove the stylus cover and release
the tonearm from the arm rest.
Set the SPEED and SIZE switches.
Move the ARM-ELEVATION switch to the
DOWN position.
Push the START/STOP switch to
start record play.
To stop the player while a record is
being played, press the START/STOP
switch.
s OD Ob Wh =