Identifying The Card In Your System - Nvidia 900-9X4B0-0012-0T1 User Manual

b. Determine the correct orientation of the connector to the card before inserting the
connector. Do not try and insert the connector upside down. This may damage the
adapter card.
c. Insert the connector into the adapter card. Be careful to insert the connector straight
into the cage. Do not apply any torque, up or down, to the connector cage in the
adapter card.
d. Make sure that the connector locks in place.

When installing cables make sure that the latches engage.

Always install and remove cables by pushing or pulling the cable and
connector in a straight line with the card.
3. After inserting a cable into a port, the Green LED indicator will light when the physical
connection is established (that is, when the unit is powered on and a cable is plugged into
the port with the other end of the connector plugged into a functioning port). See
Operations under the Interfaces section.
4. After plugging in a cable, lock the connector using the latching mechanism particular to the
cable vendor. When data is being transferred, the Green LED will blink. See
Operations under the Interfaces section.
5. Care should be taken as not to impede the air exhaust flow through the ventilation holes. Use
cable lengths which allow for routing horizontally around to the side of the chassis before
bending upward or downward in the rack.
6. To remove a cable, disengage the locks and slowly pull the connector away from the port
receptacle. The LED indicator will turn off when the cable is unseated.

Identifying the Card in Your System

On Linux
Get the device location on the PCI bus by running lspci and locating lines with the string "Mellanox
Technologies":
lspci |grep -i Mellanox
Network controller: Mellanox Technologies MT27710 Family
On Windows
1. Open Device Manager on the server. Click Start => Run, and then enter devmgmt.msc.
2. Expand System Devices and locate your NVIDIA ConnectX-4 Lx adapter card.
3. Right click the mouse on your adapter's row and select Properties to display the adapter card
properties window.
4. Click the Details tab and select Hardware Ids (Windows 2012/R2/2016) from
the Property pull-down menu.
[ConnectX-4 Lx]
LED
LED
18