Bracket Replacement Instructions - Nvidia 900-9X4B0-0012-0T1 User Manual

3. Shut down your system if active:
Turn off the power to the system, and disconnect the power cord. Refer to the system
documentation for instructions. Before you install the ConnectX-4 Lx card, make sure that
the system is disconnected from power.

Bracket Replacement Instructions

The card is usually shipped with an assembled high-profile bracket. If this form factor is suitable for
your requirements, you can skip the remainder of this section and move
If you need to replace the high-profile bracket with the short bracket that is included in the
shipping box, please follow the instructions in this section.

Due to risk of damaging the EMI gasket, it is not recommended to replace the bracket more
than three times.
To replace the bracket you will need the following parts:
• The new brackets of the proper height
• The 2 screws saved from the removal of the bracket
Removing the Existing Bracket
1. Using a torque driver, remove the two screws holding the bracket in place.
2. Separate the bracket from the ConnectX-4 Lx card.

Be careful not to put stress on the LEDs on the adapter card.
3. Save the two screws.
Installing the New Bracket
to Installation Instructions.
15