Table of Contents
Advertisement
FRONT PANEL FACILITIES
se eo wo wo mto.ceo axe
ome aes me ge
Li
HI
@
POWER
SWITCH
( POWER
)
When this switch is pressed to the ON position, power is
supplied to the unit's main circuits. To turn the power off,
press once again.
@® LINE OUT SELECTOR
( LINE OUT SELECTOR
)
These selectors are monitor switches which allow you to
listen either to the sounds created by the equalizer, or to the
original signal without equalizer coloration. When switches
SOURCE ~ TAPE 2 are pressed, the signals are output from
the unit without regard to the input level control setting or
equalizer coloration.
EFFECT:
This switch is pressed when you wish to
listen to sounds with added equalizer ef-
fects. The signals output from the record-
ing terminals
(TAPE
1 REC,
TAPE
2
REC) on the rear panel will be the same
as the sounds heard from the speakers.
The signals output from the recording ter-
minals
will not be changed
even
if the
TPAE 1, TAPE 2, or SOURCE switches
{explained below) are pressed.
Press this switch when you wish to listen to
programs played back from the tape deck
connected to the TAPE 2 terminals with-
out sounds being affected by the equal-
izer unit controls.
Press this switch when you wish to listen to
programs played back from the tape deck
connected to the TAPE
1 terminals with-
out sounds being affected by the equali-
zer unit controls.
Press this switch when you wish to listen to
program
sources
(FM
broadcasts,
record
player, etc.) which are connected
to the
equalizer unit's INPUT terminals, without
sounds
being
affected
by the equalizer
unit controls. Also, if two or ali three of
these switches
are pressed together, the
switch
farthest
right
will
be
given
Ss
priority.
TAPE 2:
TAPE 1:
SOURCE:
.
NOTE:
Even if the equalizer or the auto fader is not used, turn the power
switch on for playback.
@ EQUALIZER
CHARACTER
SELECTOR
( EQ CHARACTER
)
This switch is pressed when you wish to invert all bands of
the frequency
compensation
curve set with the graphic
equalizer controls.
NORMAL:
For normal compensation, the switch is press-
ed to the NORMAL
position.
The
graphic
equalizer controls are moved, and the frequen-
cy compensation curve of the pattern set with
the controls is effected normally.
REVERSE:
When you wish to invert all bands of the fre-
quency compensation curve set during norrnal
compensation,
press
the
switch
to
the
REVERSE position.
@ EQUALIZER LEVEL SELECTOR
(H
+12dB/ = +6 dB )
This selector
is used to choose
the ratio of frequency
boosting/ attenuation.
+ 12 dB:During normal compensation, the switch should be
pressed to the + 12 dB position.
+6 dB: When
you wish to proportion the compensation
curve in finer gradations, press the selector switch
to the + 6 GB position. In this position, the overall
volume of boosting/attenuation will be cut in half,
allowing you
to set the GRAPHIC
EQUALIZER
CONTROLS to more delicate effects.
@ EQUALIZER SELECTOR ( EQUALIZER
)
This
selector
allows
you
to choose
the
mode
(TAPE,
SOURCE) affected by the equalizer.
TAPE:
Press this switch to the ON position when you
wish to add equalizer effects to tape playback
sounds.
Advertisement
Table of Contents
