Pioneer GR-551 Operating Instructions Manual

Operating
Instructions
GRAPHIC EQUALIZER
R-551
Thank. you.for buying this. Pioneer product.
Please read through these operating instructions so you will
know how to. operate your mode! properly: After you have +
finished reading the.instructions, put them away in a safe
place for future reférence.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown in
the: explanatory. drawings. However, the method of con-
PEST
necting and operating the unit is the same.
WARNING :710 Prevent FIRE OR SHOCK HAZ-
ARD, DO. NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear
panel..Please.write.this.serial number.on. your enclosed .war-
ranty card and keep it ina secure area. This is for your
security. :
[For.Canadian model]
CAUTION:10: Prevent ELecTRIC SHOCK DO
NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS: THE
BLADES. CAN BE FULLY INSERTED TO PREVENT BLADE
EXPOSURE.
ATTENTION: pour prevenin tes cHocs
ELECTRIQUES NE PAS UTILISER CETTE FICHE POLARISEE
AVEC UN PROLONGATEUR UNE PRISE DE COURANT OU
UNE AUTRE SORTIE DE COURANT, SAUF SI LES LAMES
PEUVENT ETRE INSEREES A FOND SANS EN LAISSER
AUCUNE PARTIE A DECOUVERT.
Ae
LINE VOLTAGE. SELECTOR SWITCH
Only: multi-voltage models are: 'provided' with' this.
switch. U.S., Canadian, European, U.K., and Australian
models. are not provided with' this 'switch.
Mains. voltages in Saudi..Arabia:.are.127V and: 220V:
only. Never use this model! with 110V setting in Saudi
Arabia.
The line voltage selector switch ison the' rear: panel. Before
your-model-is.shipped from the factory, this switch is setto
the power requirements of the destination. Check ghat it is set
properly before plugging the power cord into the KC outlet. if
the voltage is not properly set or if you move:to an area where
the voltage requirements differ, adjust the selector switch ag
follows.
eo
'Use a medium-sized (flat-blade): screwdriver..(nsert the:
tip of the screwdriver into the groove of the selector
switch and turn it so that the power voltage marking of
your area points: to the arrow:
VOLTAGE SELECTOR
Medium-sized screwdriver
@ PIONEER'
The future of sound and vision.
ie