Zanussi MC 20 MB Instructions For The Use And Care page 16

Removal/replacement of the oven
liner panels
It is not necessary to disconnect the
appliance from the electricity supply
when removing the side and base panels.
However, you must disconnect the
electricity supply before attempting to
remove tlie back panel, by turning off at
the wall socket or cooker box.
From time to time it will be necessary to
remove the oven liner panels to facilitate
cleaning. To do this proceed as follows:
1. Pull out and remove the oven floor
liner.
2. Unscrew the ring nuts securing the
side runners, and remove the runners
(Fig. 7).
3. Slide the side panels towards you to
release them from their retaining pins,
then lift away from the oven wall (Fig. 8).
4. Make sure that the electricity supply
to the appliance is disconnected. Then
using a suitable Philips screwdriver
unscrew the four fixing screws on the
back panel, and lift the panel away
(Fig. 9). This is a good opportunity to
clean the rear side of the back panel.
5. To replace the panels, reverse the
above procedure.
Fig. 8