To Install The Onecta App; To Set The Wireless Connection - Daikin FTXP20N5V1B9 Operation Manual

5 Operation
5.4.2

To install the ONECTA app

1 Go to Google Play (for Android devices) or the App Store (for
iOS devices) and search for "ONECTA".
2 Follow the directions on the screen to install the ONECTA app.
INFORMATION
Scan the QR code to download and install the ONECTA
app on your
5.4.3

To set the wireless connection

There are two options to connect the wireless adapter with your
smart device.
▪ Connect the wireless LAN to your smart device directly.
▪ Connect the wireless LAN to your home network. The wireless
LAN will communicate with your smart device in your home
network using a modem, router or a similar device.
For more information and FAQ refer to app.daikineurope.com.
1 Stop operation before setting the wireless connection.
2 Use the wireless remote control to select the wireless LAN
setting menu.
Note: During setting, always aim the wireless remote control at the
infrared signal receiver on the unit.
Menu Description
Connection status check
WPS connection setting
Reset to factory default
Wireless LAN OFF
To confirm the wireless LAN connection status
1 On home screen menu, press and hold
5 seconds while the unit is not operating.
Result: The SP (wireless connection setting menu) appears.
is blinking.
(5 sec.)
2 Press to confirm the selection.
Result: is blinking.
3 Check the operation and timer LEDs on the indoor unit display.
a
b
ON/OFF
a Operation LED
b Timer LED
If operation ...and timer LED... ...then wireless LAN is...
LED...
blinks blinks
Operation manual
10
mobile phone or tablet:
for at least
not connected
If operation ...and timer LED... ...then wireless LAN is...
LED...
is off blinks in 0.5 second
interval
is off blinks in 1 second
interval
4 Press to exit the menu.
Result: The display will return to the default screen.
To connect the wireless LAN to your home
network
The wireless adapter can be connected to your home network using
the:
▪ WPS button (Wi-Fi Protected Setup) on the router (if present),
▪ The SSID (Service Set Identifier) and the KEY (password) -
located on the unit.
To connect using the WPS button
To reset the connection setting to the factory
default
Reset the connection setting to the factory default in case you want
to:
▪ disconnect the wireless LAN and the communication device (e.g.
router) or smart device,
▪ repeat the setting if the connection was unsuccessful.
1 On home screen menu, hold
the unit is not operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu by pressing twice or repeatedly.
(5 sec.)
3 Hold for at least 2 seconds to confirm the selection.
Result: is blinking. The operation and timer LEDs are blinking
at the same time in 1 s interval. The setting is reset to the
factory default.
4 Press to exit the menu.
Result: The display will return to the default screen.
To turn off the wireless LAN connection
If you want to turn off the wireless connection function:
1 On home screen menu, press
while the unit is not operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu
FTXP20~35N5V1B9 + ATXP20~35N5V1B9
running and ready to connect
to the home network via WPS
button on the router.
▪ connected to the home
network via SSID + KEY.
or
▪ connected to the home
network via WPS button on
the router.
for at least 5 seconds while
2×
for at least 5 seconds
by pressing once or repeatedly.
R32 Split series
3P717028-5D – 2023.08