Hisense PureFlat RF22B3FSE Operation Manual page 26

Cleaning and care
Although this appliance
automatically defrosts, a layer of frost
may occur on the freezer
compartment's interior walls if the
freezer door is opened frequently or
kept open too long.
If the frost is too thick, choose a time
when the freezer is nearly empty and
proceed as follow:
1. Remove existing food and
accessories baskets, unplug the
appliance from the mains power and
leave the doors open.
Ventilate the room thoroughly to
accelerate the process.
2. When defrosting is completed,
clean your freezer as described
above.
Warning
Do not use sharp objects to
remove frost from the freezer
compartment.
Only after the interior is
completely dry should the
appliance be switched back on
and plugged back into the mains
socket.
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause
seals to stick to the cabinet and tear
when you open the door. Wash the
seals with a mild detergent and warm
water. Rinse and dry them thoroughly
after cleaning.
Replacing the LED light
To replace the LED light, the below steps
can be followed:
1 Unplug your appliance
.
2. Hold a thin blade, insert it into the gap
at either end of the lampshade, and tilt
one end of the lampshade.
3. Move the blade insertion position to
the other end and tilt the lampshade
section by section until the lampshade
falls off.
4. Press the elastic snap of the light box
with a thin-blade screwdriver, and pull
one end of the elastic snap of the LED
light until the LED light is detached and
then pull out the connecting terminal of
the LED light.
5. Replace the LED light,
lampshade correctly in place.
Warning
The LED light should be replaced
by a professional. If the LED light is
damaged, contact the customer
helpline for assistance.
.
install it and
24