Helpful hints and tips……………………21 Description of the appliance…………….13 Troubleshooting…………………………22 Disposal of the appliance………………24 Display controls…………………………..15 Brief Introduction Thank you for your choosing Hisense. We aerosol cans with flammable are sure you will find your new refrigerator propellant in this appliance.
Important Safety Instructions General safety and daily use Electrical Safety It is important to use your To avoid the risks that are appliance safely. always present when using an recommend that you follow the guidelines electric appliance, we recommend that below.
Page 4
Caution: Risk of Fire Make sure that the plug is not squashed or damaged. Otherwise, it may cause Don't store products which short circuit, electric shock or overheat contain flammable propellants and even cause a fire. (e.g. spray cans) or explosive substances ...
Installing Your New Appliance Before using the appliance for the first time, you should be informed of the following tips. Warning! For proper installation, this refrigerator must be placed on a level surface of hard material that is the same height as the rest of the flooring.
Page 6
Allen Wrench (4mm) Wrench (8mm) Philips Screwdriver Disassembling the fridge door Some models may be slightly different from pictures. If some parts shown in the picture cannot be found in your appliance, please ignore the relevant description. 1. With the door closed, remove the 3 screws holding the top cover (A) with Philips (+) screwdriver, and then remove the top cover with the entire-harness...
Page 7
hinges with a wrench (8mm) and 1 ground movable part. screws (C) attached to the hinge with Philips (+) screwdriver. Remove the upper left and right door hinges (D). Note: Arrow on the water line coupler should point to the direction of the door. 2.
Page 8
Re-assembling the freezer door To reattach the drawer after you moved appliance final location, assemble the parts in reverse order. Installing the water lines and filter (Only applicable for models with ice maker) A water dispenser with a filter is one of the helpful features on your new appliance.
Page 9
3. Connect the water line installation kit (not included) to the shutoff valve. 4. Turn the main water supply back on, then turn on the shutoff valve and flush out the tubing until the water runs clear. Note: The initial dark discoloration of water is normal.
Page 10
1 Connect the water supply line to the stoppers of the water filter. compression fitting (assembled with a 1/4" tube, included in refrigerator). If you are using copper tubing, slip the compression nut (not supplied) and ferrule (not supplied) on the copper tubing (not 2) Fully insert the 1/4"...
Page 11
3) Insert two clips in the install pack as shown below, and then confirm that each clip holds the water line firmly. 1. Fully insert one head of the water line (1/4") into the outlet of water filter. 2. Insert a clip in the proper position as the figure shown below and confirm that the clip holds the water line (1/4") firmly.
Page 12
outlet correctly. Warning! The water line (1/4") length should be After turning on the shutoff valve, make less than 5m. If the water line is too long sure that there is no leakage at all (>5m), the ice and cold water content may connection points of the water lines.
Description of the Appliance Cold air vent Note! Due to unceasing modification of our products, your refrigerator may be slightly different from this instruction manual, but its functions and using methods remain the same. To get the best energy efficiency of this product, please place all shelves, drawers and baskets on their original position as per the illustration above.
Page 14
Note! Due to unceasing modification of our products, your refrigerator may be slightly different from this instruction manual, but its functions and using methods remain the same. To get the best energy efficiency of this product, please place all shelves, drawers and baskets on their original position as the illustration above.
Display Controls Your product has one control panel which is installed on the top cover, it may be different depending on the model. Use your appliance according to the following control guidelines. Models with ice maker Models without ice maker When the appliance is powered on for the control, then press and hold the Fridge first time, the backlighting of the icons on...
Page 16
First of all, you need to purchase a new increments. water filer. You can purchase the new filter through the Hisense after-sales service system. Before that, please check that the new filter is the same filter type that came Super Freeze...
When the refrigerator is powered on, all Alarm the icons of the control panel will light up When fridge or freezer door has been for 3 seconds, and a buzzer sounds. And opened for over 2 minutes, door alarm will the temperature setting reverts back to the sound.
Page 18
for models with ice maker) Automatic Ice maker can make ice automatic。 Note: Don't push the dispenser lever forward without cup, it may cause the water leak from the dispenser. Note: Do not immediately removing your cup or When the ice maker dumps ice into the glass from the dispenser after dispensing ice box, any sounds you hear are part of water you need.
Cleaning and care hygienic reasons appliance regularly. It will be easier to clean when (including exterior and interior accessories) food stocks are low. Wipe the inside of the should be cleaned regularly at least every fridge freezer with a weak solution of two months.
Page 20
Door seals cleaning dry should the appliance be powered on. Take care to keep door seals clean. Sticky food and drinks can cause seals to stick to Replacing the LED light the cabinet and tear when you open the Warning: The LED light must be replaced door.
Helpful hints and tips Fruit and vegetables: Energy saving tips We recommend that you follow the tips They should be stored in the special below to save energy. drawer provided. Try to avoid keeping the door open for Butter and cheese: long periods in order to conserve energy.
Switching off your appliance socket. If the appliance needs to be switched off 3. Clean and dry the interior thoroughly. for an extended period, the following steps 4. Ensure that all the doors are wedged should be taken prevent mould on the open slightly to allow air to circulate.
Page 23
Clicking noise before the compressor starts. Clicking noise when you get the water. The motor running noises when you get ice. Other unusual noises are due to the reasons below and may need you to check and take action: The cabinet is not level.
Is the water pressure less than30 psi? Install a booster pump to compensate for the low pressure. Is the freezer temperature too warm? Try setting the freezer temperature lower. Ice maker is not making the ice fast enough. Please wait for at least 90 minutes.
Need help?
Do you have a question about the RF208N6CSE and is the answer not in the manual?
Questions and answers