Hisense PureFlat RF22B3FSE Operation Manual page 15

Installing your new appliance
Connecting to the water supply
line
1. You may need to purchase below
items to complete this connection. And
you may find these items sold as a kit at
a local hardware store.
a Ferrule (Sleeve) -1 pcs
a b c
b 1/4" Compression nut
- 1 pcs
c 1/4" Water line - 1 pcs
2 Unplug refrigerator or disconnect
.
power.
3. Close shut off value.
4. Thread a 1/4 " compression nut and
ferrule (sleeve) onto the free end and of
1/4" water line.
5. Insert the free end and of the 1/4"
water line into the brass fitting attached
to the water inlet on the back of the
refrigerator.
6. Slide the 1/4" compression nut over
the ferrule (sleeve) and screw the 1/4"
compression nut onto the brass fitting.
7. Confirm 1/4" water line is secure by
gently pulling on it.
c 1/4" Water line
b 1/4" Compression
nut
a Ferrule (Sleeve)
d Brass fitting
e Water inlet
8. Turn on water supply and check for
leaks, and correct any leaks.
Use only the new tubing supplied
with the refrigerator. Old tubing
should not be used.
After connected to the water
supply line, please open the
water valve to flush the filter for 5
minutes before use. The initial
dark discoloration of water is
normal.
When you connect the water line
to the appliance and press the
lever of the dispenser for the first
time, it is normal that there will be
a sound of exhaust coming out
from the appliance.
Caution
The water line must be connected
to the cold water
pipe. If it is connected to the hot
water pipe, it may cause the
purifier to malfunction.
Avoid contamination of pipes
during installation.
Connect to potable water
supply only.
Note
13