Manufacturer's Contact Details; Ec Declaration Of Conformity; Intended Use - Modulift MOD 24 User Instructions

Supplementary User Instructions

1. Manufacturer's Contact Details

Modulift UK Ltd
Cordite House, 4 Holton Point, Holton Heath
Trading Park, Poole, Dorset, BH16 6FL,
Website: www.modulift.com
E-mail: info@modulift.com Tel.: +44 1202 621511
2. Introduction
These supplementary instructions are an original
instruction in accordance with section 1.7.4
(Instructions and Annex II Declarations) of the EC
Machinery Directive 2006/42/EC, and are to be read
in conjunction with Modulift's User Instructions
that accompany Generic products, and/or in
conjunction with the GA Drawing(s) issued for
job-specific custom designs.

3. EC declaration of conformity

With reference to the EC Declaration of Conformity
accompanying all new Modulift products, the
declaration is also referenced below:
We declare that the CE-marked products described
in these supplementary user instructions are in
compliance with the essential requirements and
fulfil all the relevant provisions of the Directive
2006/42/EC, and as a minimum in conformance
with the following harmonized standards / applied
technical standards:
BS EN 13155: 2003+A2:2009
●
BS EN 1993-1-1: 2005
●
The products can be incorporated as part/s of
a CE-marked lifting assembly but must in that
case not be put into service until the final lifting
assembly has been declared in conformity with the
provisions of the Directive 2006/42/EC.
Our management system complies with ISO
9001:2015 / ISO 14001: 2015 / ISO 45001: 2018 and
is certified by DNV – Business Assurance (Certificate
no. 176391-2015-AIMS-GBR-UKAS valid until 1st
April 2024)
If the products are modified without approval from
Modulift UK Ltd, this declaration becomes invalid,
and used at user's own risk.
Poole, 12.05.20
Modulift UK Ltd tel: +44(0)1202 621511 email: sales@modulift.com www.modulift.com
Technical Representative: Sue Spencer
4. Markings
Modulift products have an engraved stainless steel
I.D. plate containing key information welded to
each component. However, there are some small
components that are not physically big enough
to have a plate welded to them, therefore the
key information is engraved directly onto the
component.
In accordance with the directive 2006/42/EC
section 1.7.3, all components are marked with:
CE mark
●
Modulift's website address (contact details)
●
Product name and/or size/designation
●
WLL (note: for products that have varying WLL's
●
depending on the assembled configuration, the
WLL is referenced in a table in the specific User
Instructions)
Unique identification serial number
●
Year of manufacture
●
Self weight of component
●
Additional marking are permitted, provided that
it is applied using low stress punches on the I.D.
plates, or applied as labels.

5. Intended use

Modulift products are generally items used for
Lifting i.e. lifting accessories. These products
must only be used for their intended use, as
per the detailed User Instructions / GA Drawing
accompanying these products. For example, a
Spreader Beam designed for compression forces
must never be used as a Lifting Beam which is
designed for bending forces. Detailed technical
data and intended use can be found on the specific
User Instructions / GA Drawings specific to the
product.
Temperature rating of Modulift main generic
products: rated to -20°C to 60°C. Custom products
may differ, to be stated on certificate.
Fatigue: Fatigue failure can occur even if the