Table of Contents
Advertisement
Camera Recording
Using the LCD Monitor
Before you begin...
The LCD (Liquid Crystal Display) monitor
* Connect the Palmcorder to a power source.
can be used while recording.
Í Press the LCD-OPEN button to unlock
the LCD monitor.
2 Swing the LCD monitor tully open
and adjust the angle.
* Rotating the LCD monitor while it is
only partially open may block the
cassette door and cause damage to
the Palmcorder body.
LCD AUTO ON
* Set the LCD-POWER switch to
AUTO ON. The LCD monitor will then
tum on/off according to the
Palmcorder's POWER switch setting.
* When the LCD monitor is turned ON,
the Viewfinder automaticaily turns
OFF.
* If the LCD monitor is rotated 180? to
face the same direction as the lens/
subject, the Viewfinder turns back on
allowing both you and the subject to
monitor the recording.
LCD POWER OFF
* Set the LCD-POWER switch to OFF
to have Viewfinder on only.
* When the LCD monitor is completely
closed, it will shut-off automatically to
save power even if the LCD-POWER
switch is left on.
+ When the LCD monitor turns off, the
Viewfinder turns on autornatically.
Start recording (see page 20).
Note:
* Using the LCD monitor reduces battery
operating time.
* You cannot monitor the sound from the speaker
during recording. Connect the earphone (M3
type, not supplied) to PHONE (earphone) jack
and adjust the volume of the earphone using
the VOLUME control.
* Close the LCD monitor completely when not in
use.
21
Advertisement
Table of Contents
