MTD 315-800-000 Owner's Manual page 7

FIGURE 10.
FIGURE 11.
16. Move the shifting rod up or down until the
-drive clutch bracket shows in the locating
slot. See figures 10 and 11.
17. Place the shift lever in neutral (N) position.
Screw the shift rod in or out until it fits into
the hole in the shift lever (drive clutch must
still be showing in the locating slot). When
shift rod is adjusted to the correct length, in¬
sert the end into the hole in the shift lever.
Secure with hairpin cotter (K) as shown in
-figure 12.
FIGURE 12.
7