Table of Contents
Advertisement
DATE/TIME SETTING
The date and time can be recorded on your tapes to act as a handy reference when viewing them at a
later time. Use the following procedure to set up this display for the current date and time.
Make sure that the current time is displayed correctly before you start recording.
NOTE:
Be sure to insert the clock battery before setting the date and time. Although the date and time
can be set without the clock battery inserted, they will disappear when the battery providing power to
the camera/recorder is removed.
'I. Slide the CAM/OFF/VIDEO switch to "CAM".
2. Press the DATE/DISP. button.
"0:00"
and
"1/1/1997"
appears
in
the
viewfinder or LCD monitor and "1" flashes.
3. Press the F.FWD button to select correct date.
Hold button down to advance rapidly. If you go
past the date you want to set, press the
REW/REVIEW button. When the correct date
appears, press the STOP button.
4. Press the F.FWD button to select correct
month. Hold button down to advance rapidly.
If you go past the month you want to set, press
the REW/REVIEW button. When the correct
month appears, press the STOP button.
5. Press the F.FWD or REW/REVIEW button to
select year, and then press the STOP button.
6. Press the F.FWD or REW/REVIEW button to
select correct hour, and then press the STOP
button.
7. Press the F.FWD or REW/REVIEW button to
select correct minute.
8. After setting to the correct minute, press the
DATE/DISP. button to change the display and
start the internal clock.
it
is
recommended
that
you
press the
DATE/DISP. button to match the time signal.
NOTE:
After the date and time are set, "©
AUTO" appears and the camera/recorder enters
the automatic date recording mode. See "DATE
RECORDING" on page 20.
■ To correct date/time after starting the date/
time
1. Press and hold the DATE/DISP. button, and
then press STOP button. The date starts flash¬
ing.
2. Correct the incorrect digit by using the F.FWD,
REW/REVIEW and STOP buttons.
■ To correct date/time during programming
1. Press the STOP button repeatedly until the
digit that is incorrect flashes.
2. Correct the incorrect digit by using the F.FWD,
REW/REVIEW and STOP buttons.
Advertisement
Table of Contents
