Location Requirements - Whirlpool WDF550SAAW Manual

Parts Supplied
Check that all parts are included. See separate parts list for
accessories available for your dishwasher.
A
A. #8 x 9" Phillips flat-head wood screws
B. Phillips color-matched toekick screws
Lm gga pay, Them, omen omen ae, 9, Beeps Location Requirements
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility.
m Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
Install the dishwasher as specified in these instructions.
m_ Have everything you need to properly install dishwasher.
m Protect dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by the
warranty.
mg This dishwasher is manufactured for indoor use only.
g_ Install and level dishwasher on a floor that will hold the weight,
and in an area suitable for its size and use.
g_ Install dishwasher in a location with easy access to water,
electricity and drain.
m Fully enclosed on both sides, back, and top.
Minimum Clearances
NOTES:
m Corner locations require 2" (5.1 cm) minimum clearance
between the side of the dishwasher door and the wall or
cabinet.
gw Aminimum of 25%" (65.1 cm) is required in front of the
dishwasher to allow the door to open fully.
m Opening should be square, and the floor should be level.
A. 2" (5.1 cm) minimum clearance C. Countertop
for door opening D. 25 58" (65.1 cm) minimum
B. Dishwasher
Product Dimensions
Side View
«x 24" (61 cm)* |
SS
3214" to 3414"
(82.6 to 87.6 cm)
ne
-«—_16 5/8"(42.2 cm)—>| -~«— 214" (6.2 cm)
* To front of door frame
<—— 23 smtsosem) =
Rear View