Troubleshooting; Maintenance; Service - Delta 36-T30 T3 Manual

All DELTA machines and accessories are manufactured to high quality standards and are serviced by a network
®
of Authorized Service Centers. To obtain additional information regarding your DELTA® quality product or to obtain
parts, service, warranty assistance, or the location of the nearest service center, please call 1-800-223-7278.
To reduce the risk of injury, turn unit off and disconnect it from power source before installing
and removing accessories, before adjusting or when making repairs. An accidental start-up can
cause injury.
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry
compressed air. All plastic parts should be cleaned
with a soft damp cloth. NEVER use solvents to clean
plastic parts. They could possibly dissolve or otherwise
damage the material.
Wear certified safety equipment for
eye, hearing and respiratory protection
while using compressed air.
LUBRICATION & RUST
PROTECTION
Apply household floor paste wax to the machine table
or other work surfaces weekly. Or use a commercially
available protective product designed for this purpose.
Follow the manufacturer's instructions for use and
safety.
To clean cast iron tables of rust, you will need the
following materials: a sheet of medium Scotch-Brite™
Blending Hand Pad, a can of WD-40® and a can of
degreaser. Apply the WD-40 and polish the table
surface with the Scotch-Brite pad. Degrease the table,
then apply the protective product as described above.
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our website at www.DeltaMachinery.
com. You can also order parts from your nearest Authorized Warranty Service Center or by calling Technical Service
Manager at 1-800-223-7278 to receive personalized support from one of our highly-trained representatives.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information about DELTA® Power
Equipment Corporation Authorized Warranty Service Center, visit our web site at www.DeltaMachinery.com or call
our Technical Service Manager at 1-800-223-7278. All repairs made by our service centers are fully guaranteed
against defective material and workmanship.
You can also write to us for information at DELTA® Power Equipment Corporation, 99 Rousch Street, Anderson, SC
29625. Attention: Technical Service Manager. Be sure to include all of the information shown on the nameplate of
your tool (model number, type, serial number, date code, etc.)

TROUBLESHOOTING

MAINTENANCE

FENCE LUBRICATION
1. Apply paste wax to the fence and the guide tube
2. Apply grease to the cam lock, and the cam foot (A)

SERVICE

11
sliding surfaces weekly.
(Figure 18) occasionally to prevent wear.
FIGURE 18
A