Table of Contents
Advertisement
TROUBLESHOOTING GUIDE
Plug into an earthed outlet.
Do not remove an earth prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, re,
or electrical shock.
PROBLEM
If Stand Mixer warms up
during use
If the Flat Beater hits the Bowl
The Speed Control Lever does
not move smoothly or easily
If your Stand Mixer should fail
to operate, please check the
following
Note:
If the problem cannot be corrected, See the "Warranty and Service" section.
Do not return the Stand Mixer to the retailer; retailers do not provide service.
KITCHENAID and the design of the stand mixer are trademarks in the U.S. and elsewhere.
10
W11674488A.indb 10
W11674488A.indb 10
WARNING
Electrical Shock Hazard
Under heavy loads with extended mixing time periods, you
may not be able to comfortably touch the top of the unit.
This is normal.
Stop the Stand Mixer. See the "Product Assembly" section
and adjust the Beater to Bowl Clearance.
To move the Speed Control Lever with ease, lift slightly up
as you move it across the settings in either direction.
Is the Stand Mixer plugged in?
Is the fuse in the circuit to the Stand Mixer in working order?
If you have a Circuit Breaker Box, be sure the circuit is
closed.
Turn off the Stand Mixer for 10-15 seconds, then turn it back
on. If the Stand Mixer still does not start, allow it to cool for
30 minutes before turning it back on.
©2023 All rights reserved.
SOLUTION
6/9/2023 2:50:42 PM
6/9/2023 2:50:42 PM
Advertisement
Table of Contents
