Cisco Nexus 93180YC-FX3 Hardware Installation Manual page 9

Overview
The following figure shows the switch features on the port side of the chassis.
1 1PPS and 10MHz SMB ports
2 GPS/GNSS antenna connector
3 LEDs
Note Time of Day, and PTP GM is not supported
To determine which transceivers, adapters, and cables are support this switch, see the
Modules Compatibility Information
The following figure shows the switch features on the power supply side of the chassis.
1 Power supply modules (1 or 2) (AC
power supplies shown) with slots
numbered 1 (left) and 2 (right)
2 Fan modules (4) with slots
numbered from 1 (left) to 4 (right)
3 Console port
Port Shutdown or Active with Passive Copper Cables only (Max. power consumption up to
0.1W).
Once 10g-tx is configured on yellow ports, ports to the left, right, top and bottom of the yellow
port are referenced as blue ports. These adjacent ports will then support only low power Passive
Copper DAC cable, or these can be left empty to conserve power. If 10g-tx configuration is
removed from adjacent yellow ports, the blue ports will revert to behaving like normal ports.
Active Port deploying any Cisco 1/10/25G optics (SFP, SFP+, SFP28) EXCLUDING SFP+
10GBASE-T, with max power consumption up to 1.5W. These ports are not part of any scheme
and can deploy all regular Cisco optics and behave like normal ports.
document.
4
5
6
Cisco Nexus 93180YC-FX3 ACI-Mode Switch Hardware Installation Guide
4 48 100M/1/10/25-Gigabit Ethernet SFP28 ports
5 6 10/25/40/50/100-Gigabit QSFP28 ports
Management port (RJ45)
USB port
ToD port
Overview
Cisco Transceiver
3