Table of Contents
Advertisement
3
Installation
Refer to the nearest Authorised
Service Agent for installation of your
product. To make the product ready
for use, make sure that the electricity,
tap water supply and water drainage
systems are appropriate before
calling the Authorised Service
Agent. If they are not, call a qualified
technician and plumber to have any
necessary arrangements carried out.
C
Preparation of the location and
electrical, tap water and waste
water installations at the place of
installation is under customer's
responsibility.
B
Installation and electrical
connections must be carried out
by the Authorised Service Agent.
Manufacturer shall not be held
liable for damages that may arise
from procedures carried out by
unauthorised persons.
B
Prior to installation, visually check
if the product has any defects on
it. If so, do not have it installed.
Damaged products cause risks for
your safety.
A
Make sure that the water inlet
and discharge hoses are not
folded, pinched or crushed while
pushing the product into its place
after installation or cleaning
procedures.
When placing the product, pay
attention not to damage the floor,
walls, piping, etc. Do not hold the
product from its door or panel to
move it.
Appropriate installation
location
·
Place the product on a solid and
flat floor that has sufficient load
carrying capacity! The product
must be installed on a flat surface
in order for the door to be closed
comfortably and securely.
·
Do not install the product at
places where temperature may
fall below 0ºC.
·
Place the product at least 1 cm
away from the edges of other
furniture.
·
Place the product on a rigid floor.
Do not place it on a long pile rug
or similar surfaces.
A
Do not place the product on the
power cable.
·
Make sure that you select a
location that will allow you to
load and unload the dishes in a
fast and comfortable manner.
·
Install the product in a place close
to the tap and the drain hole.
Select the installation location
by considering that it will not be
changed after the connections
are made.
Connecting water supply
C
We recommend attaching a filter
on the house/apartment supply
water inlet to protect the machine
from damages that may arise
from impurities (sand, dirt, rust,
etc.) coming from the urban water
supply system or from your own
water system as well as to prevent
complaints such as yellowing or
7 EN
Advertisement
Table of Contents
