Table of Contents
Advertisement
machine will fulfill the necessary
operations required to cancel the
programme.
C
There might be residues of
detergent or rinse aid left in the
machine and / or on the pieces
being washed depending on the
step the programme you have
cancelled was in.
Salt indicator ( )
Please check the salt indicator on
the display to see whether there is
adequate amount of softening salt
in the dishwasher or not. You need
to refill the salt reservoir with salt
whenever salt warning indicator
appears on the display of your
machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.
Rinse Aid indicator ( )
Please check the rinse aid indicator
on the display to see whether there
is adequate amount of rinse aid in the
dishwasher or not. You need to refill
the rinse aid reservoir with rinse aid
whenever rinse aid warning indicator
appears on the display of your
machine.
End of programme
End of Programme indicator will light
up once the washing programme is
over.
1. Press the On/Off button to turn
off your machine.
2. Close the tap.
3. Unplug the machine from the
socket.
C
For energy saving, the product is
automatically turned off following
the completion of the programme
or if the programme is not started.
C
Leave your dishes in the machine
for about 15 minutes to cool down
after they are washed. Your dishes
will dry in a shorter time if you
leave the door of your machine
ajar during this period. This
process will increase the drying
effectiveness of your machine.
Water cut-off warning
If mains water is cut or water inlet
tap is turned off the machine cannot
take water in and E:02 icon will
flash on the programme indicator.
As long as the problem continues,
washing programme is paused and
the water inlet is checked regularly
by the machine; when the water is
restored E:02 icon will disappear after
a while and the washing programme
resumes.
Overflowing warning
If the machine intakes too much
water or there is leakage at any of the
components then the machine will
detect this and E:01 icon will flash
on the Programme indicator. As long
as the overflowing continues safety
algorithm will be active and try to
discharge the water. If overflowing
stops and safety is assured, E:01
icon will disappear. If E:01 does not
disappear, there is a permanent fault.
In this case the authorised service
should be contacted.
38 EN
Advertisement
Table of Contents
