Summit FasTrack SU85307 Instructions

Summit FasTrack™ Phone Holder
Instructions
SU85307
!
WARNING
!
WARNING
NOTE: The FasTrack™ Phone Holder is rated for phones from 2" to 3.75" wide.
ASSEMBLY
Insert bracket into FasTrack™ rail
1
Align the Phone Holder's metal bracket inside FasTrack
rail opening on the outer edge of the seat platform
near the arm rest or on the front of the stand.
Adjust position of Phone Holder
2
Slide Phone Holder to the desired location on the
FasTrack rail, then tighten knob to secure in place.
Ensure the Phone Holder is fully secured to the
FasTrack rail system before use.
Phone Holder Base Swivel
3
To change the angle of the phone holder base, raise
the lever as shown in the figure. Rotate the base to
the desired position and re-engage the lever into its
lower position so that the base is secure and does
not rotate freely.
PRINTED IN CHINA
2021_SU85307_Phone Holder_EN_FR_1-8-20_FINAL.indd 1 2021_SU85307_Phone Holder_EN_FR_1-8-20_FINAL.indd 1
© 2021 Summit Treestands, LLC • PO Box 1295 • Birmingham, AL 35201
www.summitstands.com
ALWAYS ENSURE THAT THE GREEN TOURNIQUET STRAP IS INSTALLED
ACCORDING TO THE MANUFACTURER'S INSTRUCTIONS ON THE
VIPER
®
Always ensure that the green tourniquet strap is installed according to the manufacturer's
instructions on the Viper Pro SD seat platform prior to using this product.
®
PRO SD SEAT PLATFORM PRIOR TO USING THIS PRODUCT.
FORM#: SU85307-21 - 01/2021
1/8/21 4:26 PM 1/8/21 4:26 PM