Troubleshooting - Husqvarna Power Axe 350i Operator's Manual

4. Examine the groove in the guide bar for wear.
Replace the guide bar if it is necessary.
5. Examine if the guide bar tip is rough or very worn.
User interface
LED screen Possible faults
The warning in- Chain brake is
dicator flashes. engaged.
Temperature
deviation.
Overload. The
saw chain can
not move.
The power trig-
ger and the
start/stop but-
ton are pushed
at the same
time.
Green activate Low battery
LED flashing. voltage.
The warning in- Service.
dicator is on.
Battery
LED display
Green LED flashes.
1844 - 006 - 13.07.2023
6. Make sure that the bar tip sprocket turns freely and
that the lubricating hole in the bar tip sprocket is not
blocked. Clean and lubricate if it is necessary.
7. Turn the guide bar daily to extend its life cycle.

Troubleshooting

Possible solution
Disengage the chain brake.
Let the product to cool down.
Release the saw chain.
Release the power trigger to activate the product.
Charge the battery.
Speak to your servicing dealer.
Possible faults
Low battery voltage.
Possible solution
Charge the battery.
33