Syntax OLEVIA LT32HV Series User Manual page 21

TV Installation and Connection Guide
1.Using Audio and S Video cables, connect the satellite receiver's Audio
and S Video OUT jacks to the TV Audio and S Video IN jacks.
2.Connect a 75-ohm coaxial cable from your cable or antenna to the TV
Ant (Antenna) jack.
Rear of TV
75-ohm coaxial cable
Satellite Receiver or Cable Box
VIDEO-2 ` VIDEO
© ©
S-VIDEO S-VIDEO
S VIDEO cable
A/V cable with RCA connector
Component2 Componenti
® ©
Note: When you connect video equipment to both the same Video and
S Video input jacks, display will automatically select S Video first.
To view S Video signal, please disconnect Video jack or turn off the
Video signal on the video equipment.
S-Video is strongly recommended for use if your VCR or video equipment
has it because S-Video input has better quality of picture than a composite
Video signal.
Note: You can also use the Video 2 jacks located on the TV rear, or
Video 3 located on the right side of the display to connect additional
video equipment.
18