Table of Contents
Advertisement
PIO Mode [Auto]
Selects the PIO mode. Configuration options: [Auto] [0] [1] [2] [3] [4]
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1]
[SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2]
[UDMA3] [UDMA4] [UDMA5] [UDMA6]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer. Configuration options: [Disabled]
[Enabled]
2.3.5
Storage Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press <Enter> if you wish to
configure the item.
IDE Configuration
ATA/IDE Configuration
Port0 SATA AHCI Speed: GEN 1 (1.5 Gb/sec)
Hard Disk Write Protect
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
ATA/IDE Configuration [Enhanced]
Allows you to configure ATA/IDE. Configuration options: [Disabled] [Compatible]
[Enhanced]
The following item shows only when you set the ATA/IDE Configuration to
Compatible.
Legacy IDE Channels [SATA PRI, PATA SEC]
Allows you to select legacy IDE channels. Configuration options: [SATA Only]
[PATA Pri, SATA Sec] [SATA Pri, PATA Sec] [PATA Only]
Hard Disk Write Protect [Disabled]
Allows you to enable or disable the device write protection. This will be effective
only if device is accessed through BIOS.Configuration options: [Disabled]
[Enabled]
ASUS P5KPL-E
[Enhanced]
[Disabled]
[35]
[Host]
Options
Disabled
Compatible
Enhanced
2-17
Advertisement
Table of Contents
