Table of Contents
Advertisement
1.4
Before you proceed
Take note of the following precautions before you install motherboard components
or change any motherboard settings.
•
•
•
•
•
Onboard LED
The motherboard comes with a standby power LED that lights up to indicate
that the system is ON, in sleep mode, or in soft-off mode. This is a reminder
that you should shut down the system and unplug the power cable before
removing or plugging in any motherboard component. The illustration below
shows the location of the onboard LED.
P5KPL-E
P5KPL-E Onboard LED
1-6
Unplug the power cord from the wall socket before touching any
component.
Use a grounded wrist strap or touch a safely grounded object or
a metal object, such as the power supply case, before handling
components to avoid damaging them due to static electricity.
Hold components by the edges to avoid touching the ICs on them.
Whenever you uninstall any component, place it on a grounded
antistatic pad or in the bag that came with the component.
Before you install or remove any component, ensure
that the ATX power supply is switched off or the power cord is detached
from the power supply. Failure to do so may cause severe damage to the
motherboard, peripherals, and/or components.
ON
Standby
Power
SB_PWR
OFF
Powered
Off
Chapter 1: Product introduction
Advertisement
Table of Contents
